Lasko T38305 Manuel télécharger pdf (Page 2)

New 9/12

T38305ES

New 9/12

T38305ES

Conjunto De Soportes De Columna

Figura 1

Base de

Soporte B

Copas

Conjunto de la Base de Soporte

Vista des de Arriba

Figura 3

Cable Eléctrico

Soportes De Columna

Base Del Motor

FUNCIONAMIENTO

Este Ventilador puede hacerse funcionar mediante los Controles

Manuales ubicados en la parte superior de la unidad o con el

Control Remoto (se muestra en la Figura 5).

1. Coloque el ventilador sobre una superficie firme y nivelada.

2. Conecte el cable eléctrico a un tomacorriente de 120 voltios.

3. Conecte la energía eléctrica a su ventilador pulsando el Botón

Alimentación ( ).

4. VELOCIDAD DEL VENTILADOR: Ahora puede ajustar la velo-

cidad del ventilador al nivel deseado - , 2 (mediana) ó 1 (baja)

- pulsando el Botón Velocidad ( ).

5. OSCILACIÓN: Oprima el Botón de Oscilación ( ) para activar y

desactivar la función de oscilación.

6. FUNCIÓN DE TEMPORIZADOR: Este ventilador está equipado

con un temporizador. El temporizador puede ser programado

1 hora a 7 horas. Continúe oprimiendo el Botón Temporiza-

dor ( ) para lograr el tiempo de programación deseado. Para

cancelar el temporizador, presione el botón del temporizador

hasta que se apague la luz.

7. Después de apagar el Ventilador, desconecte la unidad del toma-

corriente eléctrico.

IMPORTANT SAFETY INFORMATION

When using electrical appliances, basic precautions should always be followed to reduce

the risk of fire, electrical shock and injury to persons, including the following:

Read all instructions before using this Fan.

TO REDUCE THE RISK OF FIRE, ELECTRICAL SHOCK OR PERSONAL INJURY, ALWAYS

FOLLOW THESE IMPORTANT SAFETY INSTRUCTIONS AND WARNINGS:

DO NOT use this fan to ventilate areas where flammable liquids or vapors are used, stored or are present, including paints,

gasoline, varnishes, floor refinishing products or solvents. ALWAYS read and follow all warnings and instructions on the con

tainers for these products!

ALWAYS be sure the plug fits tightly into the outlet. When plugs fit loosely into outlets, they may slip partially out of the

outlet and create a poor connection. This may cause outlets to overheat and create a potential fire hazard. Outlets in this

condition should be replaced by a qualified electrician.

ALWAYS unplug the power cord when servicing, cleaning or moving the Fan. DO NOT use the ON/OFF switch as the sole

means of disconnecting power. NEVER leave children unattended when the Fan is on or plugged in. ALWAYS turn off and

unplug the Fan when not in use.

BE CERTAIN that the power source for the Fan is 120V AC. DO NOT plug the Fan into 240V or other power source.

The Blue Plug™ on your Lasko fan is a safety feature. It contains a non-replaceable safety device (fuse) that should not be

removed or tampered with. To reduce the risk of fire, electric shock and personal injury, DO NOT attempt to remove, replace,

repair or tamper with the originally supplied plug. If the Fan has stopped functioning, it may be due to the safety device incor-

porated in this plug. Call 800-233-0268, Monday - Friday, between 8:00 a.m. and 5:00 p.m. Eastern for questions. If the plug

warning label is missing or damaged, call the toll free number for a replacement label.

THIS FAN HAS A POLARIZED PLUG (one blade is wider than the other). This plug is designed to fit into the outlet only one

way. Match the wide blade to wide slot in outlet and FULLY INSERT. DO NOT attempt to bypass or defeat this safety feature.

If the plug does not fit in the outlet, consult a qualified electrician. The outlet may need to be replaced.

• AVOID the use of extension cords, power strips, power taps, outlet style air fresheners or other cord connected device, as these

devices may overheat and cause a fire hazard.

•DO NOT route power cord under rugs, carpets, runners or furniture. This may damage the cord or cause it to overheat creating a fire

hazard.

•ALWAYS place the Fan on a stable, flat, level surface while in operation to prevent the Fan from overturning.

•NEVER insert or allow fingers or objects to enter grill openings while Fan is in operation or injury and/or damage to the Fan may occur.

•DO NOT block, cover or obstruct air flow to or from the fan while in operation.

•DO NOT use this Fan outdoors or near water or wet locations such as a bath tub, pool or hot tub. Use of this Fan in a wet location

may create a shock hazard.

•DO NOT run cord under carpeting. Do not cover cord with throw rugs, runners, or similar coverings. Do not route cord under furniture

or appliances. Arrange cord away from traffic area and where it will not be tripped over.

•NEVER use a single extension cord to operate more than one Fan or other electrical device.

•DO NOT use this Fan in a window. Rain may create an electrical hazard.

•DO NOT use this Fan if it has been damaged or is not functioning properly.

•THIS FAN DOES NOT MEET THE REQUIREMENTS OF NEC ARTICLE 547-7 (2008).This Fan is not suitable for use in agricultural

facilities including areas where livestock, poultry or other animals are confined. Please refer to National Electric Code (NEC) Article

547-7 (2008), or applicable state or local codes or standards relating to electrical requirements for agricultural buildings.

•THIS FAN DOES NOT MEET THE REQUIREMENTS OF NEC ARTICLE 500 (2008).This Fan is not suitable for use in hazardous

locations. Please refer to National Electric Code (NEC) Article 500 or applicable state or local codes or standards relating to electrical

requirements for hazardous locations.

NOTICE: This equipment has been tested and found to comply with the limits for a Class B digital device, pursuant to Part 15 of the

FCC Rules. These limits are designed to provide reasonable protection against harmful interference in a residential installation. This

equipment generates uses and can radiate radio frequency energy and, if not installed and used in accordance with the instructions,

may cause harmful interference to radio communications. However, there is no guarantee that interference will not occur in a particu-

lar installation. If this equipment does cause harmful interference to radio or television reception, which can be determined by turning

the equipment off and on, the user is encouraged to try to correct the interference by one or more of the following measures: Reorient

or relocate the receiving antenna. Increase the separation between the equipment and receiver. Connect the equipment into an outlet

on a circuit different from that to which the receiver is connected. Consult the dealer or an experienced radio/TV technician for help.

The user is cautioned that changes and modifications made to the equipment without the approval of manufacturer could void the

user’s authority to operate this equipment.

CAUTION

Conjunto de Columna Para la Base

Conjunto de la

Base de Soporte

Conjunto De

Soportes De Columna

Tornillo de

mariposa

Canal Conductor de

Cable

Figura 4

ENSAMBLAJE

1. Para un ensamblaje fácil, coloque el ventilador sobre

una superficie suave.

2. Ubique el cable eléctrico en la parte inferior del

ventilador. Coloque el cable eléctrico dentro del canal

del cable en el Apoyo de columna. (Figura 1)

3. Conecte el Ensamblaje de soporte de columna al

encajar las dos mitades de la columna e insertarla en

la parte inferior del ventilador. (Figura 1)

4. Voltee el ventilador hacia abajo y alinee las flechas

en la columna y la parte inferior del ventilador. Gire en

el sentido de las agujas del reloj para bloquearlo.

Utilice un tornillo de mariposa para fijar la columna al

ventilador. (Figura 2)

5. Arme la base interconectando las salientes en la base

de apoyo A dentro de los orificios de salientes en la

base de apoyo B. Introduzca el cable eléctrico a través

del orificio grande en el centro del ensamblaje de la

base de apoyo. (Figura 3)

6. Conecte la base a la columna y fije con tornillos de

mariposa. (Figura 4)

Parte trasera

del ventilador

Flecha de

alineación

Columna

Tornillo

mariposa

Flecha de

alineación

Base de

Soporte A

Figura 2

1 2 3 4

Commentaires sur ces manuels

Pas de commentaire

Lasko T38305 Manuel Page 2

Commentaires sur ces manuels