Lasko U11300 Manuel télécharger pdf (Page 2)

New 10/13

U11300ES

New 10/13

U11300ES

MODELO U11300

FUNCIONAMIENTO (Figura 1)

1. Cuidadosamente retire el Ventilador de la bolsa plástica y la

caja. Arme la unidad siguiendo estas instrucciones.

2. Coloque el ventilador sobre una superficie firme y nivelada.

ADVERTENCIA: Los tacos de plástico o hule, tales como

las patas de esta unidad, pueden pegarse a la superficie de

los muebles. La unidad podría dejar un residuo capaz de

oscurecer, manchar o dejar marcas permanentes en el acabado

de ciertas superficies de muebles, incluyendo superficies y

pisos de madera.

3. Conecte el cable eléctrico a un tomacorriente de 120 voltios.

Asegúrese que el enchufe encaje firmemente en el tomacorriente.

Cuando los enchufes quedan flojos en los

tomacorrientes, pueden deslizarse parcial o

completamente fuera del tomacorriente con un leve

movimiento del cable adosado. Los tomacorrientes

en este estado podrían sobrecalentarse y representar

un grave peligro de incendio; si está cubierto por una

cortina o tela, el riesgo de incendio es aún mayor.

4. Encienda el Ventilador seleccionando la velocidad deseada

con la situada al costado del Ventilador. (Figura 1)

5. Para ajustar el ángulo vertical, presione el panel del

Ventilador hacia delante o hacia atrás hasta la posición

deseada. Es normal escuchar un sonido de clic mientras

realiza esta función. (Figura 2)

Figura 1

IMPORTANT SAFETY INFORMATION

When using electrical appliances, basic precautions should always be followed to reduce

the risk of fire, electrical shock and injury to persons, including the following:

Read all instructions before using this Fan.

TO REDUCE THE RISK OF FIRE, ELECTRICAL SHOCK OR PERSONAL INJURY, ALWAYS

FOLLOW THESE IMPORTANT SAFETY INSTRUCTIONS AND WARNINGS:

DO NOT use this fan to ventilate areas where flammable liquids or vapors are used, stored or are present, including paints,

gasoline, varnishes, floor refinishing products or solvents. ALWAYS read and follow all warnings and instructions on the

containers for these products!

ALWAYS be sure the plug fits tightly into the outlet. When plugs fit loosely into outlets, they may slip partially out of the

outlet and create a poor connection. This may cause outlets to overheat and create a potential fire hazard. Outlets in this

condition should be replaced by a qualified electrician.

ALWAYS unplug the power cord when servicing, cleaning or moving the Fan. DO NOT use the ON/OFF switch as the sole

means of disconnecting power. NEVER leave children unattended when the Fan is on or plugged in. ALWAYS turn off and

unplug the Fan when not in use.

BE CERTAIN that the power source for the Fan is 120V AC. DO NOT plug the Fan into 240V or other power source.

The Blue Plug™ on your Lasko fan is a safety feature. It contains a non-replaceable safety device (fuse) that should not be

removed or tampered with. To reduce the risk of fire, electric shock and personal injury, DO NOT attempt to remove, replace,

repair or tamper with the originally supplied plug. If the Fan has stopped functioning, it may be due to the safety device incor-

porated in this plug. Call 800-233-0268, Monday - Friday, between 8:00 a.m. and 5:00 p.m. Eastern for questions. If the plug

warning label is missing or damaged, call the toll free number for a replacement label.

THIS FAN HAS A POLARIZED PLUG (one blade is wider than the other). This plug is designed to fit into the outlet only one

way. Match the wide blade to wide slot in outlet and FULLY INSERT. DO NOT attempt to bypass or defeat this safety feature.

If the plug does not fit in the outlet, consult a qualified electrician. The outlet may need to be replaced.

• AVOID the use of extension cords, power strips, power taps, outlet style air fresheners or other cord connected device, as these

devices may overheat and cause a fire hazard.

•DO NOT route power cord under rugs, carpets, runners or furniture. This may damage the cord or cause it to overheat

creating a fire hazard.

•ALWAYS place the Fan on a stable, flat, level surface while in operation to prevent the Fan from overturning.

•NEVER insert or allow fingers or objects to enter grill openings while Fan is in operation or injury and/or damage to the Fan may occur.

•DO NOT block, cover or obstruct air flow to or from the fan while in operation.

•DO NOT use this Fan outdoors or near water or wet locations such as a bath tub, pool or hot tub. Use of this Fan in a wet location

may create a shock hazard.

•DO NOT run cord under carpeting. Do not cover cord with throw rugs, runners, or similar coverings. Do not route cord under furniture

or appliances. Arrange cord away from traffic area and where it will not be tripped over.

•NEVER use a single extension cord to operate more than one Fan or other electrical device.

•DO NOT use this Fan in a window. Rain may create an electrical hazard.

•DO NOT use this Fan if it has been damaged or is not functioning properly.

•THIS FAN DOES NOT MEET THE REQUIREMENTS OF NEC ARTICLE 547-7 (2008).This Fan is not suitable for use in agricultural

facilities including areas where livestock, poultry or other animals are confined. Please refer to National Electric Code (NEC) Article

547-7 (2008), or applicable state or local codes or standards relating to electrical requirements for agricultural buildings.

•THIS FAN DOES NOT MEET THE REQUIREMENTS OF NEC ARTICLE 500 (2008).This Fan is not suitable for use in hazardous

locations. Please refer to National Electric Code (NEC) Article 500 or applicable state or local codes or standards relating to electrical

requirements for hazardous locations.

NOTICE: This equipment has been tested and found to comply with the limits for a Class B digital device, pursuant to Part 15 of the

FCC Rules. These limits are designed to provide reasonable protection against harmful interference in a residential installation. This

equipment generates uses and can radiate radio frequency energy and, if not installed and used in accordance with the instructions,

may cause harmful interference to radio communications. However, there is no guarantee that interference will not occur in a particu-

lar installation. If this equipment does cause harmful interference to radio or television reception, which can be determined by turning

the equipment off and on, the user is encouraged to try to correct the interference by one or more of the following measures: Reorient

or relocate the receiving antenna. Increase the separation between the equipment and receiver. Connect the equipment into an outlet

on a circuit different from that to which the receiver is connected. Consult the dealer or an experienced radio/TV technician for help.

The user is cautioned that changes and modifications made to the equipment without the approval of manufacturer could void the

user’s authority to operate this equipment.

CAUTION

Figura 2

1 2 3 4

Commentaires sur ces manuels

Pas de commentaire

Lasko U11300 Manuel Page 2

Commentaires sur ces manuels

Produits connexes et manuels pour Circulateurs d'air Lasko U11300